Remote Control Device Installation (Option); Battery Installation - TOHATSU MFS 4C Owner's Manual

MFS4-5-6C_EUR_EN_141119N.book 21 ページ ２０１４年１２月６日 土曜日 午後７時４２分
ENOM00840-0
2. Remote control device
installation (option)
ENOW00850-0
Remote control box location
Install the remote control box in a position
where it is easy to reach and operate the
controls.
Make sure there are no obstacles that can
interfere with the operation of the remote
control cable.
1. Shift cable
2. Throttle cable
3. Cable harness B
ENOW00850-0
Remote control cable length
ENOW00100-A
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 inches)
or less. Otherwise, it affects the service life
of the cable.
3
Measure the distance from the remote
1, 2
control box to the outboard motor where
the remote control cable should be routed.
Prepare a cable that is 300-450mm (11.8-
17.7in) longer than the measured distance.
ENOF00841-0
Temporarily pull the cable along the
intended cable route to check its length is
sufficient.
Connect the remote control cable to the
engine, then run the cable to the remote
control box, making sure it is not sharply
bent, too taut and free from obstructions
that could interfere with steering.
ENOM00029-A

3. Battery installation

ENOW00012-0
Battery electrolyte contains sulfuric acid
and thus is hazardous, causing a burn if it
comes in contact with your skin, or poison-
ous if swallowed.
Keep battery and electrolyte away from
reach of children
When handling the battery, be sure to:
 Read all warnings shown on the battery
case
 Prevent electrolyte from coming in con-
tact with any part of your body. Contact
can cause serious burn or, if it comes in
INSTALLATION
ENOF00842-0
WARNING
21
5