A/D Control/Status Register (Adcsr) - Hitachi H8S/2646 Hardware Manual

16.2.2

A/D Control/Status Register (ADCSR)

Bit :
ADF
Initial value :
R/W : R/(W)*
Note: * Only 0 can be written to bit 7, to clear this flag.
ADCSR is an 8-bit readable/writable register that controls A/D conversion operations.
ADCSR is initialized to H'00 by a reset, and in hardware standby mode or module stop mode.
Bit 7—A/D End Flag (ADF): Status flag that indicates the end of A/D conversion.
Bit 7
ADF Description
0 [Clearing conditions]
•
When 0 is written to the ADF flag after reading ADF = 1
•
When the DTC is activated by an ADI interrupt and ADDR is read
1 [Setting conditions]
•
Single mode: When A/D conversion ends
•
Scan mode: When A/D conversion ends on all specified channels
Bit 6—A/D Interrupt Enable (ADIE): Selects enabling or disabling of interrupt (ADI) requests
at the end of A/D conversion.
Bit 6
ADIE Description
0 A/D conversion end interrupt (ADI) request disabled
1 A/D conversion end interrupt (ADI) request enabled
592
7 6 5
ADIE ADST
0 0 0
R/W R/W
4 3
SCAN CH3 CH2
0 0
R/W R/W R/W
2 1 0
CH1 CH0
0 0 0
R/W R/W
(Initial value)
(Initial value)