Task 1: Obtain The Required Information; Task 2: Divert Network Traffic To Another Router; Task 3: Access Privileged Exec Mode; Task 4: Configure Ip On An Interface - Juniper E Series Hardware Manual

4. Configure IP on an interface.
5. Mount the CD on the network host.
6. Configure access to the network host.
7. Enable the FTP server on the E-series router.
8. Identify the files to transfer.
9. Transfer the files to the user space on the E-series router.
10. Install the software release file to the system space on the E-series router.
11. Save the current configuration.
12. Reboot the system.

Task 1: Obtain the Required Information

Before you install the software, obtain the following information:
!
!
!
!
!
!

Task 2: Divert Network Traffic to Another Router

The system will be unavailable during the installation process.

Task 3: Access Privileged Exec Mode

To access this mode via the CLI:
1. Issue the enable command.
2. Type the password if the system prompts you.

Task 4: Configure IP on an Interface

Typically, you configure IP on the Fast Ethernet interface of the SRP module. To
configure IP on an interface:
The password (if one is configured) that allows you to access Privileged Exec
mode on the E-series router
The IP address of the network host
The IP address of the E-series router
The IP address of the next hop to reach the destination network (for example, a
gateway)
The login name and password for the vty line
The procedure for mounting a CD on the network host
host1>enable
Appendix B: Installing JUNOSe Software
Installing Software When a Firewall Exists
! 173