Fpc Leds And Controls On The M40E Craft Interface; Table 8: States For M40E Host Module Leds; Table 9: States For M40E Fpc Leds - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide

Table 8: States for M40e Host Module LEDs

Label
MASTER
ONLINE
OFFLINE
Related
Documentation

FPC LEDs and Controls on the M40e Craft Interface

Related
Documentation
38
All manuals and user guides at all-guides.com
Color State
Green On steadily
Green On steadily
Blinking
Red On steadily
M40e Craft Interface Alarm LEDs and Controls on page 35
M40e Craft Interface LCD Description on page 36
M40e Host Module Description on page 23
The LEDs and offline button for each FPC are located directly above it on the craft
interface, as shown in "M40e Craft Interface Description" on page 34. The red LED labeled
and the green LED labeled
FAIL
The offline button, labeled with the FPC slot number (for example,
FPC for removal from the router when pressed.

Table 9: States for M40e FPC LEDs

Label Color
Green
OK
Red
FAIL
M40e FPCs Supported on page 17
M40e Craft Interface Description on page 34
M40e Craft Interface LCD Description on page 36
Description
Host module is functioning as master.
Host module components (Routing Engine and MCS)
are installed and functioning normally.
Host module is starting up.
One or both host module components are not
installed or have failed.
indicate FPC status, as described in Table 9 on page 38.
OK
State Description
On steadily FPC is functioning normally.
Blinking FPC is starting up or going offline.
Off FPC is offline or not installed.
On steadily FPC has failed.
FPC2 ), prepares the
Copyright © 2010, Juniper Networks, Inc.