MX240 5G Universal Routing Platform Hardware Guide
38
Table 9: DPC and MPC LEDs on the Craft Interface
Label
Color
Green
OK
–
Red
FAIL
FPC LEDs on the MX240 Craft Interface
An FPC takes up two DPC slots when installed in an MX Series router. An FPC LED located
along the bottom of the craft interface indicates status. The LED corresponds to the
lowest DPC slot number in which the FPC is installed. See
Table 10: FPC LEDs on the Craft Interface
Label
Color
Green
OK
–
Red
FAIL
SCB LEDs on the MX240 Craft Interface
Each SCB has two LEDs on the craft interface that indicates its status. The SCB LEDs,
labeled
and
(
shows the status of either SCB1 DPC0, or FPC0 depending on
0
1/0
1/0
which component is installed in the multifunction slot), are located along the bottom of
the craft interface.
Table 11 on page 38
Table 11: SCB LEDs on the Craft Interface
Label
Color
Green
OK
–
Red
FAIL
State
Description
On steadily
Card is functioning normally.
Blinking
Card is transitioning online or offline.
Off
The slot is not online.
On steadily
Card has failed.
State
Description
On steadily
FPC is functioning normally.
Blinking
FPC is transitioning online or offline.
Off
The slot is not online.
On steadily
FPC has failed.
describes the functions of the SCB LEDs.
State
Description
On steadily
SCB: Fabric and control board functioning normally.
Blinking
SCB is transitioning online or offline.
Off
The slot is not online.
On steadily
SCB has failed.
Table 10 on page
38.
Copyright © 2019, Juniper Networks, Inc.