Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
Format
Mode
7.1.14 option
The command configures DHCP Server options. The <
DHCP option code. Ascii string specifies an NVT ASCII character string. ASCII character
strings that contain white space must be delimited by quotation marks. Hex string
specifies hexadecimal data. in hexadecimal character strings is two hexadecimal digits—
each byte can be separated by a period, colon, or white space.
Example:a3:4f:22:0c / a3 4f 22 0c / a34f.220c.9fed
Default
Format
Mode
7.1.14.1 no option
This command removes the options.
Format
Mode
7.2 DHCP Server Commands (Global Config Mode)
This section describes the commands you to configure the DHCP server settings for the
switch. You must be in Global Config mode to execute these commands.
7.2.1 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP
clients. Low-address and high-address are valid IP addresses; each made up of four
decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format
Mode
7-8
no next-server
DHCP Pool Config
none
option <code> {ascii string | hex <string1>
[<string2>...<string8>] | ip <address1>
[<address2>...<address8>]}
DHCP Pool Config
no option <code>
DHCP Pool Config
none
ip dhcp excluded-address <lowaddress> [highad-
dress]
Global Config
v1.0, October 2008
> parameter specifies the
code
DHCP Commands