Reload; Logging Commands; Logging Buffered; Logging Buffered Wrap - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

18.2.13 reload

This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. The LEDs on the switch indicate a successful reset.
Format
Mode

18.3 Logging Commands

This section describes the commands you use to configure system logging, and to view
logs and the logging settings.

18.3.1 logging buffered

This command enables logging to an in-memory log that keeps up to 128 logs.
Default
Format
Mode
18.3.1.1 no logging buffered
This command disables logging to in-memory log.
Format
Mode

18.3.2 logging buffered wrap

This command enables wrapping of in-memory logging when the log file reaches full
capacity. Otherwise when the log file reaches full capacity, logging stops.
Default
Format
Mode
18-22
reload
Privileged EXEC
disabled; critical
logging buffered
Global Config
no logging buffered
Global Config
enabled
logging buffered wrap
Privileged EXEC
v1.0, October 2008
System Maintenance Commands