Radius Server Primary; Radius Server Retransmit; Radius Server Timeout - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

11.2.5 radius server primary

This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server is the one that is used by default for handling
RADIUS requests. The remaining configured servers are only used if the primary server
cannot be reached. A maximum of three servers can be configured on each client. Only
one of these servers can be configured as the primary. If a primary server is already
configured prior to this command being executed, the server specified by the IP address
specified used in this command will become the new primary server. The IP address must
match that of a previously configured RADIUS authentication server.
Format
Mode

11.2.6 radius server retransmit

This command sets the maximum number of times a request packet is re-transmitted when
no response is received from the RADIUS server. The retries value is an integer in the
range of 1 to 15.
Default
Format
Mode
11.2.6.1 no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to
the default value.
Format
Mode

11.2.7 radius server timeout

This command sets the timeout value (in seconds) after which a request must be
retransmitted to the RADIUS server if no response is received. The timeout value is an
integer in the range of 1 to 30.
Default
Format
Mode
Port-Based Access and Authentication Commands
radius server primary <ipaddr>
Global Config
4
radius server retransmit <retries>
Global Config
no radius server retransmit
Global Config
5
radius server timeout <seconds>
Global Config
v3.0, January 2008
11-17