Show Serviceport; Snmp Community Commands; Show Snmpcommunity - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Flow Control
Stop Bits
Parity Type

show serviceport

This command displays service port configuration information.
Format
Mode
IP Address
Subnet Mask
Default Gateway
ServPort Configuration Protocol Current
Burned in MAC Address

SNMP Community Commands

show snmpcommunity

This command displays SNMP community information. Six communities are supported. You can
add, change, or delete communities. The switch does not have to be reset for changes to take
effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
Format
Switching Commands
Whether Hardware Flow-Control is enabled or disabled. Hardware
Flow Control is always disabled.
The number of Stop bits per character. The number of Stop bits is
always 1.
The Parity Method used on the Serial Port. The Parity Method is always
None.
show serviceport
Privileged EXEC
The IP address of the interface. The factory default value is 0.0.0.0
The IP subnet mask for this interface. The factory default value is
0.0.0.0
The default gateway for this IP interface. The factory default value is
0.0.0.0
Indicates what network protocol was used on the
last, or current power-up cycle, if any.
The burned in MAC address used for in-band connectivity.
show snmpcommunity
202-10102-01, May 2005
8-25