Switches Exchanging Rip Packets Do Not Learn Routing Information; Interface Send And Receive Rip Versions; Rip Interface Supply And Listen Status - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

Switches exchanging RIP packets do not learn routing
information
This section describes the troubleshooting process you can use to diagnose and resolve a situation
where RIP-enabled neighbor switches exchange RIP packets, but do not learn advertised routing
information.

Interface send and receive RIP versions

Ensure that the send and receive versions match for RIP-enabled VLANs or Ethernet interfaces.
Checking interface send and receive RIP versions
Determine if matching RIP versions are configured for sending and receiving on RIP–enabled
interfaces.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip rip interface command.
3. Observe and note the Send and Receive RIP versions configured for RIP–enabled
interfaces.
Configuring interface send and receive RIP versions
Configure the send and receive versions to matching settings for RIP-enabled VLANs or Ethernet
interfaces.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. Enter the ip rip send version <notsend/rip1/rip1comp/rip2> command.
3. Enter the ip rip receive version <rip1/rip1orrip2/rip2> command.

RIP interface supply and listen status

Ensure that RIP supply and listen are enabled for VLANs and Ethernet interfaces.
July 2015

Switches exchanging RIP packets do not learn routing information

Comments on this document? infodev@avaya.com
Troubleshooting Avaya VSP 7000 Series
87