Ip Routing Command; Ip Max-Route-Entries Command; Arp Command - Avaya P334T-ML User Manual

ip routing Command

Use the ip routing command to enable IP routing. The no form of this
command disables the IP routing process in the device. By default, IP routing is
enabled.
The syntax for this command is:
[no] ip routing

ip max-route-entries Command

This command exists for compatibility with P550. There is no limitation on the size
of the routing table, except for the amount of available memory.
The syntax for this command is:
[no] ip max-route-entries <value>
value

arp Command

Use the arp command to add a permanent entry to the Address Resolution
Protocol (ARP) cache. The no form of this command removes an entry, either a
static entry or a dynamically learned entry.
The syntax for this command is:
[no] arp <ip-address> <mac-address>
ip-address
mac-address
Example:
To add a permanent entry for station 192.168.7.8 to the ARP cache:
Router(configure)# arp 192.168.7.8 00:40:0d:8c:2a:01
To remove an entry to the ARP cache for the station 192.168.13.76:
Router(configure)# no arp 192.168.13.76
P334T-ML User's Guide
number of entries
IP address, in dotted decimal format, of the station
MAC address of the local data link
Chapter 7 CLI – Layer 3
169