Show Software Status; Displaying The Agent And Image Software Load - Avaya 3500 series Getting Started

Show software status

You can display the currently loaded and operational switch software status for both agent and
diagnostic loads. You can use the show boot ACLI command and variables to display the
agent or diagnostic load status individually, or combined.

Displaying the agent and image software load

Display the currently loaded and operational software status for agent and image loads, either
individually or combined, for a switch.
Procedure
1. Log on to ACLI in User Exec command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample output of the show boot command.
3524GT-PWR+>show boot
Unit Agent Image Active Image Diag Image Active Diag
----- ----------- ------------ ---------- -----------
1# 5.0.0.041
* - Unit requires reboot for new Active Image to be made operational.
# - Unit requires reboot for new Diag to be made operational.
3524GT-PWR+>
Variable definitions
The following table describes the parameters for the show boot command.
diag
image
Getting Started
show boot [diag] [image]
5.0.0.041
Variable
t1116
Value
Displays information for the agent load only.
Displays information for the image load
only.
Show software status
March 2013 89