Set spantree Commands
Use the set spantree command to enable/disable the spanning-tree protocol
(STP) for the stack.
Note: When you disable STP, blocking ports are disabled in order to prevent loops
in the network. As a result, you should wait 30 seconds before disabling STP if you
reset the switch, enabled STP, or inserted a new station.
The syntax for this command is:
set spantree {enable|disable}
Example:
P330-N# set spantree enable
bridge spanning tree enabled.
Set spantree priority Command
Use the set spantree priority command to set the bridge priority for STP.
The syntax for this command is:
set spantree priority <bridge_priority>
bridge_priority
Example:
This example shows how to set the bridge priority to 45000:
P330-N# set spantree priority 45000
Bridge priority set to 45000.
Set autopartition Command
Use the set autopartition command to enable or disable auto-partitioning on
all the half duplex ports of the stack.
The syntax for this command is:
set autopartition {enable|disable}[module]
Avaya P333R-LB User's Guide
Number representing the priority of the bridge.
The priority level is from 0 to 65535, with 0 indicating high
priority and 65535 indicating low priority.
Chapter 5
Cajun Campus CLI – Layer 2
117