Show Mpls - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
The LSR ID is used to identify the LSR in the MPLS network. It is recommended to set the LSR ID to the
IP address of a loopback interface. If the command is not configured, by default, the LDP will
automatically select the router ID. If LDP is running, the LSR ID will not be automatically changed.
The value of the LSR ID should be unique. By default, the LSR ID is used as the transport address. It is
necessary to ensure the LSR ID is route reachable for other LSRs.
Example
This example shows how to configure the LDP LSR ID to 110.10.10.30.
Switch# configure terminal
Switch(config)# mpls ldp configuration
Switch(config-ldp)# router-id 110.10.10.30
Warning: The configuring will lead to LDP sessions restart.
Switch(config-ldp)#
67-30

show mpls

This command is used to display the MPLS settings or MPLS interfaces' status.
show mpls [interface [INTERFACE-ID]]
Parameters
interface
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MPLS settings or MPLS interfaces' status.
Example
This example shows how to display an MPLS interface's status.
Switch# show mpls interface
Interface
---------
VLAN 10
VLAN 20
Total Entries: 2
Specifies to display the MPLS interface's status.
(Optional) Specifies the interface that will be displayed. If not specified,
all MPLS interfaces' information will be displayed.
IP Address Oper Status
------------- ------------
10.90.90.1/24 UP
172.18.1.1/24 Down
767