D-Link DXS-3600 Series Reference Manual page 563

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
------------- ------------- ------------ ------- -------------- -------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
eth3/0/1
eth3/0/2
Total Entries: 10
Switch#
45-9 show interfaces utilization
This command is used to display the switch's port utilization.
show interfaces [INTERFACE-ID [,|-]] utilization
Parameters
utilization
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the switch's physical port utilization.
Example
This example shows how to display the switch's port utilization.
Switch# show interfaces utilization
Port
----------- -------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
not-connected 1
connected trunk
connected 2
not-connected 1
(Optional) Specifies to display the utilization information.
(Optional) Specifies the interface ID. If no interface is specified, the
utilization of all physical port interfaces will be displayed.
TX packets/sec RX packets/sec
--------------
0 0
1488109 0
0 0
0 1488109
0 0
auto auto
auto auto
auto auto
auto auto
auto auto
auto auto
auto auto
a-full a-10G
a-full a-1000
auto auto
Utilization
-----------
0
50
0
50
0
563
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R
10GBASE-R