DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Uptime
Expires
Group mode
Last reporter : FE80::202:B3FF:FEF0:79D8
Group source list:
Source Address
--------------------------------------------------
2004:4::6
Total Source Entries: 1
Total Entries: 1
Switch#
Display Parameters
Uptime
Expires
Group mode
Last reporter
64-9 show ipv6 mld interface
This command is used to display MLD information on the switch.
show ipv6 mld interface [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD information on all interfaces.
: 0DT00H00M42S
: Stopped
: Include
The time elapsed since the entry has been created in the format of
[n]DT[n]H[n]M[n]S.
The time that the entry will be removed if there is no refresh on the
entry in the format of [n]DT[n]H[n]M[n]S.
Stopped indicates that the timing out of this entry is not determined by
this expire timer. If the router is in Include mode for a group, then the
whole group entry times out after the last source entry has timed out
(unless the mode is changed to Exclude mode before it times out).
Include or Exclude: The group mode is based on the type of
membership reports that are received on the interface for the group.
Last host to report being a member of the multicast group.
(Optional) Specifies the interface ID. If no interface is specified, MLD
information about all interfaces will be displayed.
Uptime
Expire
0DT00H00M42S
0DT00H03M38S
720