D-Link DXS-3600 Series Reference Manual page 565

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch#
45-11 shutdown
This command is used to disable an interface. Use the no form of the command to enable an interface.
shutdown
no shutdown
Parameters
None.
Default
By default, this option is no shutdown.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The Physical port, loopback, VLAN, tunnel, and management interfaces are valid for this configuration.
This command is also configurable for port channel member ports.
The command will cause the port to enter the disabled state. Under the disabled state, the port will not be
able to receive or transmit any packets. Using the no shutdown command will put the port back into the
enabled state. When a port is shut down, the link status will also be turned off.
Example
This example shows how to enter the shutdown command to disable the port state of interface port 1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# shutdown
565