Ip Tunnel Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

49. IP Tunnel Commands

49-1 interface tunnel
This command is used to create a tunnel and enter the interface configuration mode. Use the no
command to remove a tunnel.
interface tunnel TUNNEL-ID
no interface tunnel TUNNEL-ID
Parameters
TUNNEL-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a tunnel and enter the interface configuration mode.
Example
This example shows how to create a tunnel interface with ID 2 and enter the interface configuration mode.
Switch# configure terminal
Switch(config)# interface tunnel 2
Switch(config-if)#
49-2 tunnel source
This command is used to specify the source IPv4 address or IPv6 address for the tunnel interface. Use
the no command to remove the configuration.
tunnel source {IPV4-ADDRESS | IPV6-ADDRESS}
no tunnel source
Parameters
IPV4-ADDRESS
IPV6-ADDRESS
Default
None.
Specifies the ID of the tunnel to be added, removed or configured. The
valid range is 0 to 9999.
Specifies the source IPv4 address for the tunnel interface.
Specifies the source IPv6 address for the tunnel interface.
595