D-Link DXS-3600 Series Reference Manual page 613

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
GROUP-ADDRESS
SOURCE-ADDRESS
summary
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the content of the IPv6 multicast table. The "Uptime" timer describes the
time that the entry has been created. The "Expires" timer is the keep-alive timer of the multicast data
stream. The expires timer value is based on the PIM Sparse-mode. If the multicast data continues to
arrive on the device, this timer will refresh. If the network address is specified, the switch displays the
entries with source addresses that match the specified address. If no optional keyword is specified, all
dynamic multicast routes will be displayed.
Example
This example shows how to display multicast route brief information.
Switch# show ipv6 mroute summary
IPv6 Multicast Routing Table: 2 entries
Flags: S – Sparse
Timers: Uptime/Expires
(2000::1010:134, FF07::1), vlan1, 0DT00H01M32S/0DT00H03M20S, Flags: S
(2000::2001:101, FF06::100), vlan10, 0DT00H05M10S/0DT00H03M11S, Flags: S
Switch#
This example shows how to display multicast route entries.
Switch# show ipv6 mroute
IPv6 Multicast Routing Table – 2 entries
Flags: S – Sparse
Timers: Uptime/Expires
(2000::1010:0134, FF07::1), 0DT05H29M15S/0DT00H02M59S, Flags: S
Incoming interface: vlan1
RPF nbr: 2000::103:405
Outgoing interface list:
vlan2
vlan3
(2000::2001:0101, FF06::20), 0DT05H29M15S/0DT00H02M59S
Incoming interface: vlan10
RPF nbr: 2000::1003:405
Outgoing interface list:
(Optional) Specifies the group IPv6 address.
(Optional) Specifies the multicast source IPv6 address.
(Optional) Specifies to display a one-line, abbreviated summary of
each entry in the IPv6 multicast routing table.
613
Flags: S