D-Link DXS-3600 Series Reference Manual page 686

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure an access list for flow-based monitoring. Use the no form of this
command to remove an access list for flow-based monitoring.
monitor session SESSION-NUMBER source acl ACCESS-LIST-NAME
no monitor session SESSION-NUMBER source acl ACCESS-LIST-NAME
Parameters
session SESSION-NUMBER
acl ACCESS-LIST-NAME
Default
No monitor function is configured.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Multiple access lists can be monitored on a session at a time.
Example
This example shows how to create a monitor session with the session number 2. It assigns the MAC
access list MAC-Monitored-flow as the monitor source.
Switch# configure terminal
Switch(config)# monitor session 2 destination interface ethernet1/0/1
Switch(config)# monitor session 2 source acl MAC-Monitored-flow
Switch(config)#
61-5 monitor session source remote vlan
This command is used to configure the RSPAN VLAN for an RSPAN destination session. Use the no
form of the command to remove configuration of the RSPAN VLAN.
monitor session SESSION-NUMBER source remote vlan VLAN-ID
no monitor session SESSION-NUMBER source remote vlan
Parameters
session SESSION-NUMBER
vlan VLAN-ID
Default
None.
Specifies the session number for the port monitor session. The valid
range is 1 to 4.
Specifies the flow-based mirror.
Specifies the session number of the port mirroring session. The valid
range is 1 to 4.
Specifies the VLAN that the monitored source packets are tunneled
over from the remote site. The valid range is 2 to 4094.
686