Show Ipv6 Mroute - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the basic multicast information of the IPv6 interface or display the state of
IPv6 multicast routing. If the interface ID is not specified, this command will display the information for all
IPv6 interfaces.
Example
This example shows how to display the state of IPv6 multicast routing.
Switch# show ipv6 multicast
IPv6 multicast-routing global state: Enabled
Switch#
This example shows how to display IPv6 multicast interface information.
Switch# show ipv6 multicast interface
Interface
vlan100
vlan200
Total Entries: 2
Switch#
Display Parameters
Interface
Owner Module

52-4 show ipv6 mroute

This command is used to display the content of the IPv6 dynamic multicast routing table.
show ipv6 mroute [GROUP-ADDRESS [SOURCE-ADDRESS] | summary]
multicast information. If no specific interface ID is specified, all
interface will be displayed. If the keyword interface is not specified,
the state of IPv6 multicast routing will be displayed.
Owner Module
PIM-SM
PIM-SM
The interface name of the interface.
Indicates whether the module is enabled on the interface.
PIM-SM: PIM Sparse Mode is enabled on this interface.
612