Show Mpls Ldp Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
TCP Port
UDP Port
Max PDU Length
Initial Backoff
Max Backoff
Transport Address
Keep Alive Time
Link Hello Holdtime
Link Hello Interval
Distribution Method
LSP Control Mode
Label Retention
Loop Detection
Path Vector Limit
Hop Count Limit
Authentication
PHP
Trap Status
Switch#
67-35

show mpls ldp interface

This command is used to display LDP interface information.
show mpls ldp interface [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display LDP information on the interface.
Example
This example shows how to display LDP information on all interfaces.
Switch# show mpls ldp interface
Interface: if1
---------------------------------------
Admin State
: 646
: 646
: 1500
: 15 Seconds
: 600 Seconds
: 3.3.3.3
: 60 Seconds
: 15 Seconds
: 5 Seconds
: DU
: Ordered
: Conservative
: Enabled
: 254
: 30
: Disabled
: Explicit null
: Disabled
(Optional) Specifies the interface that will be displayed. If not specified,
all interfaces' information will be displayed.
: Enabled
772