Show Ipv6 Multicast - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
RPF-IPV6ADDRESS
INTERFACE-ID
null
all
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The PIM protocol does not have its own routing table but use the unicast routing table to determine the
reverse path forwarding interface to reach a network. The user can use the ipv6 mroute command to
configure static multicast routes to specify the RPF address for a network.
Example
This example shows how to configure the static route for multicast RPF checks.
Switch# configure terminal
Switch(config)# ipv6 mroute 2000::/64 6::6
Switch(config)#
This example shows how to configure the multicast data source within a network number 2000::/64 to be
discarded.
Switch# configure terminal
Switch(config)# ipv6 mroute 2000::/64 null
Switch(config)#
This example shows how to remove a previously configured IPv6 mroute entry of 2000::/64.
Switch# configure terminal
Switch(config)# no ipv6 mroute 2000::/64
Switch(config)#

52-3 show ipv6 multicast

This command is used to display basic multicast information of the IPv6 interface.
show ipv6 multicast [interface [INTERFACE-ID]]
Parameters
INTERFACE-ID
Specifies the IPv6 address of the next hop that can be used to reach
the specified network.
Specifies the RPF interface for the route. The interface where the RPF
neighbor IPv6 address is located is the RPF interface.
Specifies that if null is specified for the route, the RPF check result will
always fail.
Specifies to delete all IPv6 multicast static routes.
(Optional) Specifies the interface name for which to display IPv6
611