D-Link DXS-3600 Series Reference Manual page 478

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
37-4 tcn-propagation
This command is used to enable the propagation of topology change notifications from the sub-ERP
instance to the major instance. Use the no form of this command to disable the propagation of topology
change notifications.
tcn-propagation
no tcn-propagation
Parameters
None.
Default
By default, this option is disabled.
Command Mode
G.8032 Profile Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the propagation of topology change notifications from the sub-ring instance
to other ring instances.
Example
This example shows how to enable the TCN propagation state for the G.8032 profile "campus".
Switch# configure terminal
Switch(config)# ethernet ring g8032 profile campus
Switch(config-g8032–ring-profile)# tcn-propagation
Switch(config-g8032–ring-profile)#
37-5 r-aps channel-vlan
This command is used to specify the APS channel VLAN for an ERP instance. Use the no form of the
command to remove the configuration.
r-aps channel-vlan VLAN-ID
no r-aps channel-vlan
Parameters
VLAN-ID
Default
None.
Specifies the VLAN ID of the APS channel VLAN for the ERP instance.
The valid range is from 1 to 4094.
478