Digital Diagnostics Monitoring (Ddm) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
27. Digital Diagnostics Monitoring (DDM)
Commands
27-1 show interfaces transceiver
This command is used to display the current SFP module operating parameters.
show interfaces [INTERFACE-ID [,|-] transceiver [detail]
Parameters
INTERFACE-ID [,|-]
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current SFP module operating transceiver monitoring parameters values
for specified ports.
Example
This example shows how to display current operating parameters for all ports valid for transceiver
monitoring.
Switch# show interfaces transceiver
++ : high alarm, +
mA: milliamperes, mW: milliwatts#
port
-------- ------------ ------------ ------------ ------------ ------------
eth2/0/23
eth3/0/25
eth3/0/26
Total Entries: 3
Switch#
This example shows how to display detailed transceiver monitoring information for all ports which are
valid for transceiver monitoring.
Switch# show interfaces transceiver detail
(Optional) Specifies multiple interfaces for transceiver monitoring
status display. If no interface ID is specified, transceiver monitoring
statuses on all valid interfaces are displayed.
: high warning, -
Temperature Voltage
(Celsius) (V)
30.090 3.353
29.316 3.302
31.617 3.297
: low warning, -- : low alarm
Bias Current TX Power
(mA) (mW)
16.794(++) 0.258
5.326 0.529
5.170 0.527
407
RX Power
(mW)
0.000(--)
0.506
0.504