D-Link DXS-3600 Series Reference Manual page 470

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Loopback status
Remote client
Mode
MAC address
Vendor (OUI)
Max OAMPDU size
Unidirectional
Link monitoring
Variable request
PDU revision
Switch#
Display Parameters
Operation status
Max OAMPDU size
PDU revision
Unidirectional
Remote loopback
Link Monitoring
Variable request
: No loopback
: Passive
: 0001.0203.0405
: 0180c2
: 1518 bytes
: Support
: Support
: Support
: 1
Disable: OAM is disabled on this port
LinkFault: The link has detected a fault and is transmitting OAMPDUs
with a link fault indication.
PassiveWait: The port is passive and is waiting to see if the peer
device is OAM capable.
ActiveSendLocal: The port is active and is sending local information
SendLocalAndRemote: The local port has discovered the peer but
has not yet accepted or rejected the configuration of the peer.
SendLocalAndRemoteOk: The local device agrees the OAM peer
entity.
PeeringLocallyRejected: The local OAM entity rejects the remote
peer OAM entity.
PeeringRemotelyRejected: The remote OAM entity rejects the local
device.
Operational: The local OAM entity learns that both it and the remote
OAM entity have accepted the peering.
NonOperHalfDuplex: Since Ethernet OAM functions are not designed
to work completely over half-duplex port. This value indicates Ethernet
OAM is enabled but the port is in half-duplex operation.
The largest OAMPDU that the OAM entity supports. OAM entities
exchange maximum OAMPDU sizes and negotiate to use the smaller
of the two maximum OAMPDU sizes between the peers.
The configuration revision of the OAM entity as reflected in the latest
OAMPDU sent by the OAM entity. The configuration revision is used
by OAM entities to indicate that configuration changes have occurred,
which might require the peer OAM entity to re-evaluate whether OAM
peering is allowed.
It indicates that the OAM entity supports the transmission of
OAMPDUs on links that are operating in unidirectional mode (traffic
flowing in one direction only).
It indicates that the OAM entity can initiate and respond to loopback
commands.
It indicates that the OAM entity can send and receive Event
Notification OAMPDUs.
It indicates that the OAM entity can send and receive variable requests
to monitor the attribute value as described in the IEEE 802.3 Clause
30 MIB
470