D-Link DXS-3600 Series Reference Manual page 649

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
energy-efficient-eth
Default
No IEEE 802.3 Organizationally Specific TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command enables the advertisement of
the optional IEEE 802.3 Organizationally Specific TLVs. The respective TLV will be encapsulated in
LLDPDU and sent to other devices if the advertisement state is enabled.
Example
This example shows how to enable the advertising MAC/PHY Configuration/Status TLV.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp dot3-tlv-select mac-phy-config
Switch(config-if)#
58-6 lldp fast-count
This command is used to configure the LLDP-MED fast start repeat count option on the switch. Use the
no form of this command to return to the default settings.
lldp fast-count VALUE
no lldp fast-count
Parameters
VALUE
Default
By default, this value is 4.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When an LLDP-MED Capabilities TLV is detected, the application layer will start the fast start mechanism.
This command is used to configure the fast start repeat count which indicates the number of LLDP
message transmissions for one complete fast start interval.
capability of the implemented MAC and PHY.
(Optional) Specifies the energy efficient Ethernet TLV to send
Specifies the LLDP-MED fast start repeat count value. This value must
be between 1 and 10.
649