Show Errdisable Recovery - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to set the recovery timer to 200 seconds for port security violation.
Switch# configure terminal
Switch(config)# errdisable recovery cause psecure-violation interval 200
Switch(config)#
This example shows how to enable the auto-recovery option for port security violations.
Switch# configure terminal
Switch(config)# errdisable recovery cause psecurity-violation
Switch(config)#

35-2 show errdisable recovery

This command is used to display the error-disable recovery timer related settings.
show errdisable recovery
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to verify the settings of the error disable recovery timer.
Example
This example shows how to display the settings of the error disable recovery timer.
Switch# show errdisable recovery
ErrDisable Cause
-----------------
psecure-violation
storm-control
bpdu-protect
arp-rate
dhcp-rate
loopback-detect
l2pt-guard
Interfaces that will be recovered at the next timeout:
Interface
State
-----------
enabled
disabled
disabled
disabled
disabled
disabled
disabled
Errdisable Cause Time left(sec)
Interval
-----------
200 seconds
300 seconds
300 seconds
1000 seconds
1000 seconds
1000 seconds
1000 seconds
456