Show Lldp Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the LLDP system's global configurations.
Example
This example shows how to display the LLDP system's global configuration status.
Switch# show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities Supported: Repeater, Bridge
System Capabilities Enabled
LLDP-MED System Information:
Device Class
Hardware Revision
Firmware Revision
Software Revision
Serial Number
Manufacturer Name
Model Name
Asset ID
LLDP Configurations
LLDP State
LLDP Forward State
Message TX Interval
Message TX Hold Multiplier: 4
ReInit Delay
TX Delay
LLDP-MED Configuration:
Fast Start Repeat Count
Switch#
58-22

show lldp interface

This command is used to display the LLDP configuration at the physical interface.
show lldp interface INTERFACE-ID [, | -]
: MAC Address
: 00-01-02-03-04-00
: Switch
: TenGigabit Ethernet Switch
: Repeater, Bridge
: Network Connectivity Device
: B1
: 1.10.008
: 2.00.012
: D1234567890
: D-Link
: DXS-3600-16S TenGigabit Ethernet
:
: Disabled
: Disabled
: 30
: 2
: 2
: 4
661