D-Link DXS-3600 Series Reference Manual page 384

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to create a DHCPv6 guard policy and matches the IPv6 addresses in the
access list named list1.
Switch# configure terminal
Switch(config)# ipv6 dhcp guard policy dhcp_filter1
Switch(config-dhcp-guard)# match ipv6 access-list list1
Switch(config-dhcp-guard)#
24-4 ipv6 dhcp guard attach-policy
This command is used to apply a DHCPv6 guard policy on the specified interface. Use the no form of this
command to remove the binding.
ipv6 dhcp guard attach-policy [POLICY-NAME]
no ipv6 dhcp guard attach-policy
Parameters
POLICY-NAME
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to apply a DHCPv6 policy to an interface. DHCPv6 guard policies can be used to
block DHCPv6 server messages or filter server messages based on sender IP address. If the policy name
is not specified, the default policy will set the device's role to client.
Example
This example shows how to apply the DHCPv6 guard policy "pol1" to interface eth1/0/3.
Switch# configure terminal
Switch(config)# interface eth1/0/3
Switch(config-if)# ipv6 dhcp guard attach-policy pol1
Switch(config-if)#
24-5 show ipv6 dhcp guard policy
This command is used to display DHCPv6 guard information.
show ipv6 dhcp guard policy [POLICY-NAME]
(Optional) Specifies the DHCPv6 guard policy name.
384