Show Ip Ospf Neighbor - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
INTERFACE-ID
vrf VRF-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display interface information for OSPF. If the no interface type or number is
specified, OSPF information of all interfaces will be displayed.
Example
This example shows how to display interface information for OSPF.
Switch#show ip ospf interface
vlan10 is up, line protocol is up
Internet Address: 1.0.0.1/8, Area 0.0.0.0
Router ID 222.200.23.1, Network Type POINT_TO_POINT, Cost: 1
Transmit Dealy is 1 sec, State PTP, Priority 1
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Current Authentication Type: simple text
Authentication Key Configuration
Authentication type: simple text
Authentication-key: 123
vlan20 is up, line protocol is up
Internet Address: 2.0.0.1/8, Area 0.0.0.1
Router ID 222.200.23.1, Network Type BROADCAST, Cost: 1
Transmit Dealy is 1 sec, State BDR, Priority 1
Designated Router (ID) 222.200.23.2, Interface Address 2.0.0.2
Backup Designated Router (ID) 222.200.23.1, Interface Address 2.0.0.1
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Current Authentication Type: md5
Authentication Key Configuration
Authentication type: md5
Message-digest-key 1
Total Entries : 2
Switch#
71-37

show ip ospf neighbor

This command is used to display information of OSPF neighbors.
(Optional) Specifies the interface ID to display.
(Optional) Specifies to display the interfaces in the VRF process.
838