D-Link DXS-3600 Series Reference Manual page 554

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
The specified description corresponds to the MIB object "ifAlias" defined in the RFC 2233.
Example
This example shows how to add the description "Physical Port 10" to interface eth 1/0/10.
Switch# configure terminal
Switch(config)# interface eth1/0/10
Switch(config-if)# description Physical Port 10
Switch(config-if)#
45-3 interface
This command is used to enter the interface configuration mode for a single interface. Use the no form of
the command to remove an interface.
interface INTERFACE-ID
no interface INTERFACE-ID
Parameters
INTERFACE-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enter the interface configuration mode for a specific interface. The interface ID
is formed by the interface type and interface number with no spaces in between.
The following keywords can be used for the supported interface types:
•
ethernet - Specifies the Ethernet switch port with all different media.
•
null - Specifies the null interface.
•
loopback - Specifies the software only interface which always stays in the up status.
•
vlan - Specifies the VLAN interface.
•
port-channel - Specifies the aggregated port-channel interface.
•
tunnel - Specifies the virtual interface used for tunneling purposes.
•
mgmt - Specifies the Ethernet interface used for the out-of-band management port.
The format of the interface number is dependent on the interface type.
Specifies the ID of the interface. The interface ID is formed by interface
type and interface number with no spaces in between.
554