D-Link DXS-3600 Series Reference Manual page 923

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
bsr
embedded-rp
static
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If this command is issued without any parameters, all group mappings will be displayed. Specify the
group address range or learned source to filter the group mappings.
Example
This example shows how to display the RP mapping of group FF04::10.
Switch# show ipv6 pim group-map ff04::10/128
FF04::10/128
RP: 3ffe:10:10:5::153
Info source: 3ffe:10:10:5::153, via bootstrap
Switch#
This example shows how to display the RP mappings learned from a specific source enabled by static
configurations.
Switch# show ipv6 pim group-map info-source static
FF00::/8
RP: 2013:1:1:11::1
Info source:
Switch#
This example shows how to display the RP mappings learned through the embedded rendezvous point
(RP).
Switch# show ipv6 pim group-map info-source embedded-rp
FF7E:640:2002:6666::/96
RP: 2002:6666::6
Info source: embedded
Switch#
source, such as the bootstrap router (BSR) or static configuration.
Specifies to display ranges learned through the BSR.
Specifies to display group ranges learned through the embedded
rendezvous point (RP).
Specifies to display ranges enabled by static configuration.
static
923