Mpls Ldp Configuration - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to enable MPLS globally and enable MPLS on VLAN 100.
Switch# configure terminal
Switch(config)# mpls ip
Switch(config)# interface vlan100
Switch(config-if)# mpls ip
Switch(config-if)#
67-20 mpls label protocol ldp
This command is used, in the interface configuration mode, to enable LDP on this interface. This
command is used, in the global configuration mode, to enable LDP globally. Use the no command to
disable LDP.
mpls label protocol ldp
no mpls label protocol ldp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
LDP is running on an interface only when:
•
MPLS and LDP are globally enabled.
•
MPLS and LDP are enabled on this interface.
Example
This example shows how to enable LDP globally and enable LDP on VLAN 100.
Switch# configure terminal
Switch(config)# mpls label protocol ldp
Switch(config)# interface vlan 100
Switch(config-if)# mpls label protocol ldp
Switch(config-if)#
67-21

mpls ldp configuration

This command is used to enter the LDP configuration mode to configure LDP related settings.
759