Layer 2 Protocol Tunnel (L2Pt) Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

56. Layer 2 Protocol Tunnel (L2PT) Commands

56-1 clear l2protocol-tunnel counters
This command is used to clear the Layer 2 Protocol Tunnel (L2PT) statistics counters.
clear l2protocol-tunnel counters {all | interface INTERFACE-ID}
Parameters
all
interface INTERFACE-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to clear protocol tunnel counters for all interfaces or for the specified interface. Only
the physical port and port-channel interface can be specified for the command.
Example
This example shows how to clear L2PT counters for all L2PT ports.
switch# clear l2protocol-tunnel counters all
switch#
56-2 l2protocol-tunnel
This command is used to enable the protocol tunneling for the specified protocols. To disable the protocol
tunneling, use the no form of the command.
l2protocol-tunnel [gvrp | stp | protocol-mac {01-00-0c-cc-cc-cc | 01-00-0c-cc-cc-cd}]
no l2protocol-tunnel [gvrp | stp | protocol-mac {01-00-0c-cc-cc-cc | 01-00-0c-cc-cc-cd}]
Parameters
gvrp
stp
01-00-0c-cc-cc-cc
Specifies to clear counters for all interfaces.
Specifies the interface to clear counters.
(Optional) Specifies to enable tunneling for GARP VLAN Registration
Protocol (GVRP) packets.
(Optional) Specifies to enables tunneling for Spanning Tree Protocol
(STP) packets.
(Optional) Specifies to tunnel the protocol packets with this destination
DA.
630