D-Link DXS-3600 Series Reference Manual page 549

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP snooping group information.
Example
This example shows how to display IGMP snooping group information.
Switch# show ip igmp snooping groups
IGMP Snooping Connected Group Membership:
VLAN ID Group address
------- ---------------
1 239.255.255.250
Total Entries: 1
Switch#
44-22 show ip igmp snooping filter
This command is used to display IGMP snooping filter configuration information for all interfaces on the
switch or for a specified interface.
show ip igmp snooping filter [interface INTERFACE-ID [,|-]]
Parameters
INTERFACE-ID [,|-]
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the IGMP snooping limit and access group information.
Example
This example shows how to display IGMP snooping filter information when no interface is specified.
Switch# show ip igmp snooping filter
Source address FM
--------------- --
* EX
(Optional) Specifies that the interface can be a physical interface or a
port-channel. If no interface is specified, IGMP snooping filter
information on all interface will be displayed.
549
Exp(sec) Interface
-------- ---------
382 2/0/7