D-Link DXS-3600 Series Reference Manual page 638

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
57-2 lacp port-priority
This command is used to configure the port priority. Use the no form of the command to revert the port
priority to the default settings.
lacp port-priority PRIORITY
no lacp port-priority
Parameters
PRIORITY
Default
The default port-priority is 32768.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The LACP port-priority determines which ports can join a port-channel and which ports are put in the
standalone mode. The lower value has a higher priority. If two or more ports have the same priority, the
port number determines the priority
Example
This example shows how to configure the port priority to 20000 on interfaces 1/0/4 to 1/0/5.
Switch# configure terminal
Switch(config)# interface range eth1/0/4-1/0/5
Switch(config-if)# lacp port-priority 20000
Switch(config-if)#
57-3 lacp timeout
This command is used to configure the LACP long or short timer. Use the no form of this command to
return to the default value.
lacp timeout {short | long}
no lacp timeout
Parameters
short
long
Specifies the port priority. The range is 1 to 65535.
Specifies that there will be 3 seconds before invalidating received
LACPDU information and there will be 1 second between LACP PDU
periodic transmissions when using Short Timeouts.
Specifies that there will be 90 seconds before invalidating received
LACPDU information and there will be 30 seconds between LACP
638