D-Link DXS-3600 Series Reference Manual page 749

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no discovery targeted-hello accept
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If targeted hello message acceptance is disabled in the interface, and if the received targeted hello is not
coming from the local configured targeted peer, the message will be ignored.
If targeted hello message acceptance is enabled in the interface, LSR will honor the received targeted
hello messages sent by all neighbors.
Example
This example shows how to accept the targeted hello message.
Switch# configure terminal
Switch(config)# interface vlan 10
Switch(config-if)# discovery targeted-hello accept
Switch(config-if)#
67-7 discovery targeted-hello
This command is used to configure the LDP hello hold-time and hello interval for sessions to the targeted
peer. Use the no form of this command to restore the default value.
discovery targeted-hello {holdtime SECONDS | interval SECONDS}
no discovery targeted-hello {holdtime | interval}
Parameters
holdtime
interval
Default
Hold-time: 45 seconds.
Interval: 15 seconds.
Command Mode
LDP Target Peer Mode.
Command Default Level
Specifies the hold-time of the hello messages for sessions with
extended peers. The range of is from 15 to 65535.
Specifies the interval to the hello message for sessions with extended
peers. The range is from 5 to 65535.
749