D-Link DXS-3600 Series Reference Manual page 703

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
ipv6 mld snooping query-max-response-time SECONDS
no ipv6 mld snooping query-max-response-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. This command configures the period of
which the group member can respond to an MLD query message before the MLD Snooping deletes the
membership.
Example
This example shows how to configure the maximum response time to 20 seconds on an interface.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ipv6 mld snooping query-max-response-time 20
Switch(config-vlan)#
63-11 ipv6 mld snooping query-version
This command is used to configure the general query packet version sent by the MLD snooping querier.
Use the no form of this command to revert to the default setting.
ipv6 mld snooping query-version {1 | 2}
no ipv6 mld snooping query-version
Parameters
1
2
Default
By default, this version number is 2.
Command Mode
Specifies to set the maximum response time, in seconds, advertised in
MLD Snooping queries.
Specifies that the version of the MLD general query, sent by MLD
snooping querier, is 1.
Specifies that the version of the MLD general query, sent by MLD
snooping querier, is 2.
703