Expansion Module Commands - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

38. Expansion Module Commands

38-1 port-mode
This command is used to configure the expansion module's port mode.
port-mode unit UNIT-ID {1st_port | 2nd_port | 3rd_port | 4th_port} {4*10giga | 40giga}
Parameters
UNIT-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for the DXS-3600-EM-4QXS expansion module. Use this command to
configure the port to one 40GBASE-CR4 port or four 10GBASE-R ports.
Example
This example shows how to configure the 2nd port on unit 2 to four 10GBASE-R ports.
Switch# configure terminal
Switch(config)# port-mode unit 2 2nd_port 4*10giga
Switch(config)#
38-2 show module-info
This command is used to display the expansion module's information.
show module-info [unit UNIT-ID]
Parameters
UNIT-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Specifies the switch's unit ID.
Specifies the switch unit ID.
492