D-Link DXS-3600 Series Reference Manual page 707

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. This command applies to MLD snooping
on a VLAN interface to statically add group membership entries and/or source records.
The ipv6 mld snooping static-group command allows the user to create an MLD snooping static group
in case that the attached host does not support MLD protocol.
Example
This example shows how to statically add group and/or source records for MLD snooping.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping static-group FF02::12:03 interface eth3/0/5
Switch(config-vlan)#
63-16 ipv6 mld snooping suppression-time
This command is used to configure the interval of suppressing duplicate MLD reports or leaves. Use the
no form of the command to revert to the default setting.
ipv6 mld snooping suppression-time SECONDS
no ipv6 mld snooping suppression-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. Report suppression function will
suppress the duplicate MLD report or leave packets receiving in the suppression time interval. A small
suppression time will cause the duplicate MLD packets be sent up more frequently.
Example
This example shows how to configure the suppression time to be 125 on VLAN 1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ipv6 mld snooping suppression-time 125
Switch(config-vlan)#
Specifies to configure the interval of suppressing duplicates MLD
reports. The range is 1 to 300.
707