D-Link DXS-3600 Series Reference Manual page 577

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Subscriber Source IP Check
Total Entries: 1
Switch#
Display Parameters
Version
Querier
Subscriber Source IP Check
46-14 show ip igmp ssm-mapping
This command is used to display the SSM mapping configuration
show ip igmp ssm-mapping [GROUP-ADDRESS]
Parameters
GROUP-ADDRESS
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the SSM source address mapping for a specified multicast group.
Example
This example shows how to display SSM mapping configurations.
Switch# show ip igmp ssm-mapping
SSM mapping : Enabled
Switch#
This example shows how to display SSM mapping for group address 232.1.1.1.
Switch# show ip igmp ssm-mapping 232.1.1.1
: Enabled
The IGMP protocol version running on the interface.
The querier IP on the interface LAN.
This field specifies whether to ignore the source IP check on incoming
IGMP packets from subscriber.
Enable indicates not to ignore the source IP check.
Disable indicates to ignore the source IP check.
Specifies the multicast group to be displayed.
577