D-Link DXS-3600 Series Reference Manual page 716

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to configure the interval of the last listener query to 2 seconds on VLAN 1000.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ipv6 mld last-listener-query-interval 2
Switch(config-if)#
64-4 ipv6 mld query-interval
This command is used to configure the interval at which the router sends MLD Multicast Listener Query
messages. Use the no form of the command to revert to the default setting.
ipv6 mld query-interval SECONDS
no ipv6 mld query-interval
Parameters
query-interval SECONDS
Default
By default, this value is 125 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only valid for the VLAN interface. The user can use this command to modify the MLD
query interval on an interface.
The MLD querier will send the general query at the interval specified by the query interval command. On
receiving the general query, the MLD listener needs to respond the report packet to claim that it is
interested in the specified multicast group.
Example
This example shows how to configure the MLD query interval for VLAN 1000. It configures the MLD query
Interval value to 150 seconds.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ipv6 mld query-interval 150
Switch(config-if)#
64-5 ipv6 mld query-max-response-time
This command is used to configure the maximum response time advertised in MLD queries. To restore
the default value, use the no form of this command.
Specifies to configure the frequency at which the designated router
sends MLD general-query messages. The range is from 1 to 31744.
716