D-Link DXS-3600 Series Reference Manual page 729

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
PROFILE-NAME
Default
None.
Command Mode
Multicast VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A single Multicast VLAN can be bound with more than one profile as its real group range. Group ranges
cannot overlap among Multicast VLANs. A port can be member port of multiple multicast VLANs. If it is
the case, then the group permitted by the access group configured for the Multicast VLAN will be learned
with this multicast VLAN.
If a port is member port of a single multicast VLAN, if access group is configured for the multicast VLAN,
then only those group permitted by the access group are learned with the multicast VLAN. If there is no
access group configured, then all multicast group will be learned with the multicast VLAN.
Example
This example shows how to bind the profile "mv_profile1" to multicast VLAN 100.
Switch# configure terminal
Switch(config)# mvlan 100
Switch(config-mvlan)# access-group mv_profile1
Switch(config-mvlan)#
65-10 range
This command is used to configure the multicast address range for a multicast VLAN profile. Use the no
form of this command to remove a range.
range {IPV4-ADDRESS-START [IPV4-ADDRESS-END] | IPV6-ADDRESS-START [IPV6-ADDRESS-
END]}
no range {IPV4-ADDRESS-START [IPV4-ADDRESS-END] | IPV6-ADDRESS-START [IPV6-
ADDRESS-END]}
Parameters
IPV4-ADDRESS-START
IPV4-ADDRESS-END
IPV6-ADDRESS-START
IPV6-ADDRESS-END
Default
None.
Command Mode
Multicast VLAN Profile Configuration Mode.
Specifies the name of the profile.
Specifies the IPv4 multicast start address of the range.
Specifies the IPv4 multicast end address of the range.
Specifies the IPv6 multicast start address of the range.
Specifies the IPv6 multicast end address of the range.
729