DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-ldp)#
67-17
match
This command is used to apply the policy to FECs. Use the no command to remove the setting.
match {ip NETWORK-PREFIX/PREFIX-LENGTH | vc IP-ADDRESS VC-ID}
no match {all | ip NETWORK-PREFIX/PREFIX-LENGTH | vc IP-ADDRESS VC-ID}
Parameters
ip NETWORK-
PREFIX/PREFIX-LENGTH
vc IP-ADDRESS VC-ID
all
Default
By default, this option is disabled.
Command Mode
MPLS QoS Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to apply a MPLS QoS policy to FECs. The QoS policy will be applied to all MPLS
packets of the FEC. A FEC can only be bound to at most one policy.
Example
This example shows how to apply the MPLS QoS "policy1" to FEC 172.18.1.0/24.
Switch# configure terminal
Switch(config)# mpls qos policy policy1
Switch(config-mpls-qos)# match ip 172.18.1.0/24
Switch(config-mpls-qos)#
67-18
md5 authentication
This command is used to enable the LDP authentication. Use the no form of this command to restore the
default value.
md5 authentication
no md5 authentication
Parameters
None.
Specifies the IP prefix FEC.
Specifies the VC FEC.
Specifies to remove all binding FECs of the policy.
757