Debug Ipv6 Rip - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
88-11 timers
This command is used to configure the IPv6 RIP network timers. To restore the default timers use the no
form of this command.
timers UPDATE INVALID FLUSH
no timers
Parameters
UPDATE
INVALID
FLUSH
Default
The default update time: 30 seconds.
The default invalid time: 180 seconds.
The default flush time: 120 seconds.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to modify the IPv6 RIP protocol timers.
Example
This example shows how to configure the RIP timers. The Timers of update, invalid, and flush timers are
set to 10, 40, and 160 respectively.
Switch# configure terminal
Switch(config)# ipv6 router rip
Switch(config-rtr)# timers 10 40 160
Switch(config-rtr)#
88-12

debug ipv6 rip

This command is used to turn on the IPv6 RIP debug function. To turn off the IPv6 RIP debug function,
use the no form of this command.
debug ipv6 rip
no debug ipv6 rip
Parameters
None.
Specifies the update interval at which the update message is sent. The
range is from 5 to 65535.
Specifies the invalidate timer in seconds. The range is from 1 to
65535.
Specifies the flush timer in seconds. The range is from 1 to 65535.
1063