D-Link DXS-3600 Series Reference Manual page 484

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the first ring port of a physical ring.
Example
This example shows how to configure the interface eth3/0/1 as the first ring port of the G.8032 ring
"major-ring".
Switch# configure terminal
Switch(config)# ethernet ring g8032 major-ring
Switch(config-erp)# port0 interface eth3/0/1
Switch(config-erp)#
37-12 port1
This command is used to specify the second ring port of a physical ring. To remove the second ring port
setting, use the no form of this command.
port1 {interface INTERFACE-ID | none}
no port1
Parameters
INTERFACE-ID
none
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the second ring port of a physical ring. Use the port1 none command to
indicate that the interconnect node is a local node endpoint of an open ring.
Example
This example shows how to configure the interconnect node as a local end node of the G.8032 ring
"ring2".
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
Switch(config)# ethernet ring g8032 ring1
Switch(config-erps)# sub-ring ring2
Switch(config-erps)# exit
Specifies the second ring port. It can be a physical port or port-channel
interface.
Specifies none to indicate that the interconnect node is a local node
endpoint of an open ring.
484