Error Recovery Commands - D-Link DXS-3600 Series Reference Manual

Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

35. Error Recovery Commands

35-1 errdisable recovery

This command is used to enable the error recovery for causes and to configure the recovery interval. Use

the no command to disable the auto-recovery option or to return interval to the default setting for causes.

errdisable recovery cause {all | psecure-violation | storm-control | bpdu-protect | arp-rate |

dhcp-rate | loopback-detect | l2pt-guard} [interval SECONDS]

no errdisable recovery cause {all | psecure-violation | storm-control | bpdu-protect | arp-rate |

dhcp-rate | loopback-detect | l2pt-guard} [interval]

psecure-violation

storm-control

bpdu-protect

loopback-detect

interval SECONDS

Auto recovery is disabled for all causes.

Command Mode

Global Configuration Mode.

Command Default Level

Usage Guideline

A port can be put in an error disabled state by causes such as port security violations, storm control,

etc...When a port enters the error disabled state, the port is shutdown although the setting running the

configuration remains in the no shutdown state.

There are two ways to recover an error disabled port. Administrators can use the errdisable recovery

cause command to enable the auto-recovery of error ports disabled by each cause. Alternatively,

administrators can manually recover the port by entering the shutdown command first and then the no

shutdown command for the port.

Specifies to enable the auto-recovery option for all causes.