D-Link DXS-3600 Series Reference Manual page 764

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Warning: The configuring will lead to the LDP session of the peer restart.
Switch(config-ldp)#
67-26 neighbor targeted
This command is used to create an LDP targeted peer. Use the no form of this command to remove a
configured LDP targeted peer.
neighbor IP-ADDRESS targeted
no neighbor IP-ADDRESS targeted
Parameters
IP-ADDRESS
Default
None.
Command Mode
LDP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a targeted peer. The targeted peer is used to establish the LDP session
with the non-directly connected neighbor.
Example
This example shows how to create a targeted peer 110.10.10.1.
Switch# configure terminal
Switch(config)# mpls ldp configuration
Switch(config-ldp)# neighbor 110.10.10.1 targeted
Switch(config-ldp-targeted-peer)#
67-27 path-vector maxlength
This command is used to configure the maximum path vector length. Use the no form of this command to
restore the default value.
path-vector maxlength VALUE
no path-vector maxlength
Parameters
VALUE
Default
Specifies the LSR ID of the targeted peer.
Specifies the maximum path vector length. The range is from 1 to 255.
764