DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
68. Neighbor Discovery (ND) Inspection
Commands
68-1 ipv6 nd inspection policy
This command is used to create an ND inspection policy. This command will enter into the ND inspection
policy configuration mode. Use the no form of this command to remove the ND inspection policy.
ipv6 nd inspection policy POLICY-NAME
no ipv6 nd inspection policy POLICY-NAME
Parameters
POLICY-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create an ND inspection policy. This command will enter into the ND inspection
policy configuration mode. ND inspection is mainly for inspection of Neighbor Solicitation (NS) and
Neighbor Advertisement (NA) messages.
Example
This example shows how to create an ND policy name called "policy1".
Switch# configure terminal
Switch(config)# ipv6 nd inspection policy policy1
Switch(config-nd-inspection)#
68-2 validate source-mac
This command is used to check the source MAC address against the link-layer address for ND messages.
Use the no form of the command to disable the check.
validate source-mac
no validate source-mac
Parameters
None.
Specifies the ND inspection policy name.
784